Open Daily: 10am - 10pm | Alley door pickup 10am - 7pm 3038 Hennepin Ave Minneapolis, MN
612-822-4611

  • Open Daily: 10am - 10pm
    Alley-side Pickup: 10am - 7pm

    3038 Hennepin Ave Minneapolis, MN
    612-822-4611

Open Daily: 10am - 10pm | Alley-side Pickup: 10am - 7pm
3038 Hennepin Ave Minneapolis, MN
612-822-4611
Engineering Inspection Manual

Engineering Inspection Manual

Roy, Henry A.

Paperback

Technology & EngineeringGeneral Architecture

ISBN10: 0820600156
ISBN13: 9780820600154
Publisher: Chemical Pub Co Inc (Ny)
Published: Mar 8 1956
Pages: 164
Weight: 0.50
Height: 0.35 Width: 6.00 Depth: 9.00
Language: English
CONTENTS - Foreword - Why I Wrote This Book - Inspector's Creed - An Introduction to Interchangeable Parts - Scale and Hook Rule - Combination Square - Protractor - Outside Micrometer Caliper - Micrometer Depth Gage - Inside Micrometer Caliper - How to Read a Micrometer Caliper - Vernier Caliper - Vernier Height Gage - How to Read the Vernier - Surface Gage - Universal Bevel Protractor - Thickness or Feeler Gage - Screw-Pitch Gage - Small-Hole Gage - Telescoping Gage - Locating Centers - Outside and Inside Calipers - Combination Bevel - Fillet or Radius Gage - Flush-Pin Gage - Taper-Plug Gage - Last-Word Indicator - Concentricity Setup - Angle-Plate Setup - Size-Block Setup - Comparator Setup - Checking Two Different Diameters with One Setup - Vee-Block and Size-Block Setup - Checking a 45 0 Angle - Sine Bar - A Hole Drilled at Right Angles to a Step - Bench-Center Setup - Shoulder Runout - Checking the Center Distance between Two Holes - Checking the Center Distance between Two Spherical - Depressions - Checking a Taper Hole with a Taper-Plug Gage - Laying out a Rough Casting - Setting Up Light Castings - Surface Geometry - Optical Flats - Surface Shapes - Pilot Cylindrical Plug Gage - J-S Roll Thread Snap Gages - Adjustable Limit Snap Gages - Ring and Plug Thread Gages - Hoke Precision Gage Blocks - Gage-Block and Tie-Rod Assembly - Precision Gage Blocks - Electrical Harness Lacing - Lockwiring - The Thermometer and How It Works - Basic Helical Spring Designs - Fundamental Features of a Thread - Basic Points in Thread Measuring - The Microinch Scale - Nomenclature of the Circle - Geometrical Forms and Their Meaning - Calculations - How to Check Internal and External Military Pipe Threads - Step-by-Step Checking of Threads - Diametral Pitch or D. P. Calculations - Diametral Pitch Formulas - Interpretation of Mechanical Drawings - Mechanical Drawing Symbols - Indication of Materials - Indication of Direction - Miscellaneous Symbols - Abbreviations Frequently Used on Drawings - Standard System of Marking American Thread - Truncated and Full Form Thread; Setting Plug Gages - Gage Care - APPENDIX: - INDEX -

Also in

General Architecture

View All